Siemens SCALANCE S615 - Vir-Ip

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
370 Configuration Manual, 06/2015, C79000-G8976-C406-02
Requirement
You are in the IPSEC REMOTE END configuration mode.
The command prompt is as follows:
cli(config-ipsec-rmend-X)#
Syntax
Call up the command with the following parameters:
subnet <subnet|dns>
The parameters have the following meaning:
Parameter
Description
Range of values / note
subnet
IP subnet
Specify the subnet.
dns
DNS name Specify the DNS host name.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The remote subnet is configured.
Further notes
You display this setting and other information with the show ipsec remoteend command.
9.3.4.5
vir-ip
Description
With this command, you specify the subnet from which the remote station is offered a virtual
IP address.
Requirement
You are in the IPSEC REMOTE END configuration mode.
The command prompt is as follows:
cli(config-ipsec-rmend-X)#
Syntax
Call up the command with the following parameters:
vir-ip ipv4 [<subnet>]