Siemens SCALANCE S615 - No Netmap All; Netmap Show-IDX

Layer 3 functions
8.1 NAT
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
297
8.1.3.9
no netmap all
Description
With this command, you delete all NETMAP rules.
Requirement
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Syntax
Call the command without parameter assignment:
no netmap all
Result
All NETMAP rules are deleted.
Further notes
You create a NETMAP rule with the commands netmap source type ipv4 and netmap
destination type ipv4
.
8.1.3.10
netmap show-idx
Description
With this command, you show the numbers of the configured NETMAP rules.
Requirement
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Syntax
Call the command without parameter assignment:
netmap show-idx