Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
318 Configuration Manual, 06/2015, C79000-G8976-C406-02
The list is displayed.
You create a protocol with the icmp name command.
icmp show-types-codes
Description
With this command, you display the available ICMP packet types and codes.
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Call the command without parameter assignment:
icmp show-types-codes
The list is displayed.
You create a protocol with the icmp name command.
idle timeout icmp
Description
With this command, you configure the required period for ICMP. If no data exchange takes
place, the ICMP connection is terminated automatically when this time has elapsed.
You are in the FIREWALL configuration mode.
The command prompt is as follows:
To Next Page
Loading...
