Siemens SCALANCE S615 - Logon IDX Group

Functions specific to SCALANCE
3.4 SRS
SCALANCE S615 Command Line Interface
104 Configuration Manual, 06/2015, C79000-G8976-C406-02
Further notes
You display this setting and other information with the show srs overview command.
You configure the user data for the destination server with the commands
logon idx group,
logon idx name and logon idx pw.
3.4.3.6
logon idx group
Note
This command is only available with a KEY
-PLUG.
Description
With this command, you change the group name for access to a specific destination server.
Requirement
You are in the SRS configuration mode.
The command prompt is as follows:
cli(config-srs)#
Syntax
Call up the command with the following parameters:
logon idx <num(1-100)> group <string(255)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
num
Number corresponding to a specific
destination server.
Enter the required number.
group
Keyword for the group name
-
string
Group name Enter the group name.
Maximum of 255 characters
Result
The group name is changed.
Further notes
You display this setting and other information with the show srs overview command.
You create a destination server entry with the
logon addr command.