Network protocols
6.4 DHCP server
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
197
Call up the command with the following parameters:
no ip dhcp
-server pool <pool
-id (1
-5)> The parameter has the following meaning:
ID of the addressed IPv4 address band
The required IPv4 address band is deleted.
You create the IPv4 address band with the ip dhcp-server pool command.
Commands in the DHCPPOOL configuration mode
This section describes commands that you can call up in the DHCPPOOL Configuration
mode.
In the Global Configuration mode, enter the
ip dhcp-server pool command to change to this
mode.
● If you exit the DHCPPOOL Configuration mode with the
exit command, you return to the
Global Configuration mode.
● If you exit the DHCPPOOL Configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you specify how long the assigned IPv4 address remains valid. Once
this period has elapsed, the device must either request a new IPv4 address or extend the
lease time of the existing IPv4 address.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
To Next Page
Loading...
Need help?
General
