Siemens SCALANCE S615 - Commands in the CERT Configuration Mode; Show-IDX

Security and authentication
9.4 Certificates
SCALANCE S615 Command Line Interface
408 Configuration Manual, 06/2015, C79000-G8976-C406-02
9.4.2
Commands in the CERT configuration mode
This section describes commands that you can call up in the CERT configuration mode.
In the Global configuration mode, enter the
certificate command to change to this mode.
● If you exit the CERT configuration mode with the
exit command, you return to the Global
configuration mode.
● If you exit the CERT configuration mode with the
end command, you return to the
Privileged EXEC mode.
9.4.2.1
show-idx
Description
The command lists the loaded certificates and their indexes.
Requirement
● Certificates are loaded.
● You are in the CERT configuration mode.
The command prompt is as follows:
cli(config-cert)#
Syntax
Call the command without parameter assignment:
show idx
Result
The list is displayed.