Siemens SCALANCE S615 - No Vir-Ip

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
378 Configuration Manual, 06/2015, C79000-G8976-C406-02
Syntax
Call the command without parameter assignment:
vir-ip
Result
The setting is enabled.
Further notes
You display this setting and other information with the show ipsec connections command.
You disable the requesting of a virtual IPv4 address with the
no vir-ip command.
9.3.5.9
no vir-ip
Description
With this command, you disable the requesting of a virtual IPv4 address.
Requirement
You are in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(onfig-conn-X)#
Syntax
Call the command without parameter assignment:
no vir-ip
Result
The setting is disabled.
Further notes
You display this setting and other information with the show ipsec connections command.
You enable the requesting of a virtual IPv4 address with the
vir-ip command.