Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
385
The command prompt is as follows:
cli(config-conn-auth)#
Call the command without parameter assignment:
no rem-id
The remote ID is removed.
You display this setting and other information with the show ipsec conn-authentication
command.
You configure the remote ID with the
rem-id command.
Commands in the IPSEC PHASE1 configuration mode
This section describes commands that you can call up in the IPSEC PHASE configuration
mode.
In the IPSEC CONNECTION configuration mode, enter the
phase 1 command to change to
this mode.
● If you exit the IPSEC PHASE1 configuration mode with the
exit command, you return to
the IPSEC CONNECTION configuration mode.
● If you exit the IPSEC PHASE1 configuration mode with the
end command, you return to
the Privileged EXEC mode.
With this command you specify that the aggressive mode will be used.
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs1)#
To Next Page
Loading...
Need help?
General
