Siemens SCALANCE S615 - No Ip Dhcp-Server Pool

Network protocols
6.4 DHCP server
SCALANCE S615 Command Line Interface
196 Configuration Manual, 06/2015, C79000-G8976-C406-02
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp-server pool { <pool-id (1-5)> | show-interface-options }
The parameters have the following meaning:
Parameter
Description
Range of values / note
pool-id
ID of the addressed IPv4 address band
1 ... 5
show-interface-options
Displays the possible options for the interface. -
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The ID of the addressed IPv4 address band is configured.
You are now in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Further notes
You exit the DHCPPOOL configuration mode with the exit command.
You delete the entry with the
no ip dhcp-server pool command.
6.4.2.6
no ip dhcp-server pool
Description
With this command, you delete the required IPv4 address band.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#