Siemens SCALANCE S615 - Clear Seclog; Fault Report Ack

Diagnostics
10.1 Event and fault handling
SCALANCE S615 Command Line Interface
420 Configuration Manual, 06/2015, C79000-G8976-C406-02
10.1.5
clear seclog
Description
With this command, you delete the content of the security log.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameters:
clear seclog
Result
The content of the security log is deleted.
10.1.6
fault report ack
Description
With this command, you acknowledge (delete) the messages of the "Cold/Warm start" event.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameter:
fault report ack <fault-state-id>