Configuration
2.1 System
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
43
cli>
or cli#
Call the command without parameter assignment:
show lldp neighbors
The neighborhood table is displayed.
show lldp status
Description
This command shows per port whether LLDP frames are sent or received.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show lldp status[{port<interface-type><interface-id>}]
The parameters have the following meaning:
Keyword for a port description.
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on identifiers of interfaces and addresses, refer to the section "Interface
identifiers and addresses (Page 25)".
The information is displayed.
To Next Page
Loading...
Need help?
General
