Load control
7.1 Flow control
SCALANCE S615 Command Line Interface
278 Configuration Manual, 06/2015, C79000-G8976-C406-02
If you do not select any parameters from the parameter list, the information for the router will
be displayed.
The settings of the flow control function are displayed.
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
The flow control function monitors a connection at the receiving end to make sure that not
more data is received than can be processed. If flow control detects a threat of data
overflow, the partner at the sending end is sent a signal to stop transmitting.
With this command, you configure the flow control function for an interface.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
To Next Page
Loading...
