Siemens SCALANCE S615 - Dpd-Timeout; Ike-Auth

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
391
9.3.7.8
dpd-timeout
Description
With this command, you configure the timeout setting for the VPN connection. If there is no
response to the DPD queries, the connection to the remote station is declared to be invalid
after this time has elapsed.
Requirement
● DPD is enabled
● You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs1)#
Syntax
Call up the command with the following parameters:
dpd-timeout <sec(10-1000)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
sec
Period for DPD queries Enter the period of time in sec-
onds.
Result
The period of time is configured.
Further notes
You display this setting and other information with the show ipsec conn-phase1 command.
You enable DPD with the
dpd command.
9.3.7.9
ike-auth
Description
With this command, you configure the method for calculating the checksum.