Siemens SCALANCE S615 - No Auto-Fwrules

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
397
Requirement
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs2)#
Syntax
Call the command without parameter assignment:
auto-fwrules
Result
The firewall rule is created automatically for the VPN connection.
Further notes
You display this setting and other information with the show ipsec conn-phase2 command.
You disable the setting with the
no auto-fwrules command.
9.3.8.2
no auto-fwrules
Description
With this command you specify that the firewall rule will not be created automatically for the
VPN connection.
Requirement
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs2)#
Syntax
Call the command without parameter assignment:
no auto-fwrules
Result
The firewall rule is not created automatically for the VPN connection. You need to create the
firewall rule manually.