Siemens SCALANCE S615 - Auth Remcert; No Auth

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
381
9.3.6.3
auth remcert
Description
With this command you specify that the remote station certificate will be used for
authentication.
Requirement
● The certificates are loaded.
● You are in the IPSEC AUTHENTICATION configuration mode.
The command prompt is as follows:
cli(config-conn-auth)#
Syntax
Call up the command with the following parameters:
auth remcert <string(255)> localcert <string(255)>
The parameters have the following meaning:
Remote cert
Keyword for a remote station certificate
-
string
Name of the remote station certificate Specify a valid remote station
certificate.
Local cert
Keyword for a device certificate -
string
Name of the device certificate
Specify a valid device certificate.
Result
The setting is configured.
Further notes
You show the loaded certificates with the show-idx command.
You display this setting and other information with the
show ipsec conn-authentication
command.
You remove the authentication with the
no auth command.
9.3.6.4
no auth
Description
With this command, you delete the authentication method.