Description
1.6 General CLI commands
SCALANCE S615 Command Line Interface
34 Configuration Manual, 06/2015, C79000-G8976-C406-02
Abbreviated notation of commands
Description
The command interpreter of the Command Line Interface also detects commands if only the
first character of the command or its parts is entered.
This is only possible if all the parts of the abbreviated input can be assigned to exactly one
command or to the parts of the command.
The show event config command can be replaced by the expression sh e c.
Reusing the last used commands
Description
The Command Line Interface saves the last 14 commands used in a list assigned to the
particular mode. This can then only be called up in the relevant mode.
Example:
In the Global Configuration mode, all entered commands are saved. If you entered
commands earlier in the Interface Configuration mode, these commands are not included in
the list of the Global Configuration mode. You can only call up and reuse these commands in
the Interface Configuration mode.
You can page through the list of the commands most recently used using the arrow up and
arrow down keys.
If the command you are looking for is displayed, you can edit the command line as required
and execute the command with the enter key.
You display the list of commands last used with the show history command. This function is
available in every mode.
show history (Page 36)
To Next Page
Loading...
