Functions specific to SCALANCE
3.5 SINEMA RC
SCALANCE S615 Command Line Interface
112 Configuration Manual, 06/2015, C79000-G8976-C406-02
Note
This command is only available with a KEY
-PLUG.
With this command, you enable the automatic creation of the firewall and NAT rules for the
connection to the SINEMA RC Server.
You are in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Call the command without parameter assignment:
autofwnat
The automatic firewall and NAT rules are created. The connections between the configured
exported subnets and the subnets that can be reached via the SINEMA RC Server are
allowed. The NAT settings are implemented as configured in the SINEMA RC Server.
You enable the setting with the autofwnat command.
You disable the setting with the
no autofwnat command.
To Next Page
Loading...
Need help?
General
