Siemens SCALANCE S615 - Proto Show-Names

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
347
The parameters have the following meaning:
Parameter
Description
Range of values / note
name
Keyword for a protocol name -
string
Protocol name Specify a valid protocol
name.
Maximum of 32 characters
all
Deletes all protocol names
-
Result
The relevant protocol is deleted.
Further notes
You create a protocol with the proto name command.
You display the available protocol names with the
proto show-names command.
9.2.4.36
proto show-names
Description
With this command, you display the available protocol names.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call the command without parameter assignment:
proto show-names
Result
The protocol names are listed.
Further notes
You create a protocol with the proto name command.