Siemens SCALANCE S615 - Web-Session-Timeout

Functions specific to SCALANCE
3.2 WBM
SCALANCE S615 Command Line Interface
92 Configuration Manual, 06/2015, C79000-G8976-C406-02
3.2.2.1
web-session-timeout
Description
With this command, you enable the automatic logoff and you configure the timeout setting for
the WBM.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
web-session-timeout[seconds(60-3600)]
The parameter has the following meaning:
Parameter
Description
Range of values / note
seconds
Time in seconds until automatic logout
after the last entry
60 … 3600
Default: 900
Result
The time is configured and automatic logout is enabled.
Further notes
You disable automatic logoff with the no web-session-timeout command.
You display the current timeout setting with the
show web-session-timeout command.