Siemens SCALANCE S615 - Replacing the PLUG

Configuration
2.1 System
SCALANCE S615 Command Line Interface
56 Configuration Manual, 06/2015, C79000-G8976-C406-02
Further notes
You disable automatic logout with the no cli-console-timeout command.
You display the current timeout setting with the
show cli-console-timeout command.
2.1.9.7
no cli-console-timeout
Description
With this command, you disable the automatic logout.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no cli-console-timeout
Result
Automatic logout is disabled.
Further notes
You enable automatic logout with the cli-console-timeout command.
You display the current timeout setting with the
show cli-console-timeout command.
2.1.9.8
system contact
Description
With this command, you enter contact information for the system.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#