Load control
7.2 Dynamic MAC aging
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
281
show mac-address-table aging-status
Description
This command shows whether or not MAC aging is enabled.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show mac-address-table aging-status
The status of the MAC aging is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
mac-address-table aging
Description
With this command, you enable the "Aging" function. The "Aging" function ensures that an
entry in the MAC address list that was learned dynamically is deleted again after a certain
time.
You are in the Global configuration mode.
The command prompt is as follows:
To Next Page
Loading...
Need help?
General
