Siemens SCALANCE S615 - Userhost

Network protocols
6.5 DNS
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
219
Further notes
You display this setting and other information with the show ddnsclient information
command.
You enable an entry with the
no service command.
6.5.5.3
userhost
Description
With this command, you configure the host name that you have agreed with your dynamic
DDNS provider for the device, e.g. example.no-ip.com.
Requirement
You are in the DDNS Client configuration mode.
The command prompt is as follows:
cli(config-ddnsclient)#
Syntax
Call up the command with the following parameters:
userhost {show-services | <index> <host>}
The parameters have the following meaning:
Parameter
Description
Range of values / note
show-services
Lists the available providers.
-
index
Number corresponding to a specific
provider.
Specify a valid number.
host
Host name
Specify the agreed host name.
Result
The host name is configured.
Further notes
You display this setting and other information with the show ddnsclient information
command.
You configure the user name with the
username command.
You configure the password with the
password command.