Siemens SCALANCE S615 - Phase; Timeout

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
376 Configuration Manual, 06/2015, C79000-G8976-C406-02
9.3.5.6
phase
Description
With this command, you change to the IPSEC PHASE configuration mode.
Requirement
You are in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(config-conn-X)#
Syntax
Call up the command with the following parameters:
phase <num(1-2)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
num
Phase of the VPN connection
• 1: Phase 1
• 2: Phase 2
Result
You are now in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phsX)#
Further notes
You display this setting and other information with the show ipsec connections command.
9.3.5.7
timeout
Description
With this command, you configure the interval after which the VPN connection will be
terminated. If no packets are sent during this time, the VPN connection is automatically
terminated.