Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
384 Configuration Manual, 06/2015, C79000-G8976-C406-02
With this command, you configure the remote ID.
You are in the IPSEC AUTHENTICATION configuration mode.
The command prompt is as follows:
cli(config-conn-auth)#
Call up the command with the following parameters:
rem-id <string(255)>
The parameter has the following meaning:
Remote ID Enter the remote ID.
If you do not specify the remote ID, the remote ID is read from the device
certificate.
If you use PSK as the authentication, the WAN IP address is used as the
The remote ID is configured.
You display this setting and other information with the show ipsec conn-authentication
command.
You remove the remote ID with the
no rem-id command.
With this command, you remove the remote ID.
You are in the IPSEC AUTHENTICATION configuration mode.
To Next Page
Loading...
