Siemens SCALANCE S615 - SCALANCE S615

Configuration
2.1 System
SCALANCE S615 Command Line Interface
68 Configuration Manual, 06/2015, C79000-G8976-C406-02
2.1.10.12
speed
Description
With this command, you configure the transmission speed of an interface.
Note
Availability of this function
The transmission speed can only be configured for
electrical data transfer.
On optical connections, the transmission speed is fixed.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
speed {10|100}
The parameters have the following meaning:
Parameter
Description
10
Transmission speed 10 Mbps
100
Transmission speed 100 Mbps
Result
The transmission speed of the interface is configured.