Siemens SCALANCE S615 - Snmp Group

Network protocols
6.6 SNMP
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
237
no snmp filterprofile<profile-name><OIDTree>
The parameters have the following meaning:
Parameters
Description
Range of values
profile-name
Name of the filter profile
max. 32 characters
OIDTree
Object ID Path information of the MIB tree
Result
The filter is deleted.
Further notes
You create a filter with the snmp filterprofile command.
You display the created filter with the
show snmp filter table command.
6.6.2.10
snmp group
Description
With this command, you configure the details of an SNMP group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp group <GroupName> user <UserName>security-model{v1|v2c|v3}
[{volatile|nonvolatile}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
GroupName
Name of the group
max. 32 characters
user
Keyword for the user name -
UserName
Name of the user
max. 32 characters