Security and authentication
9.4 Certificates
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
409
This command shows information on the relevant certificate. e.g. the serial number.
● You are in the CERT configuration mode.
The command prompt is as follows:
cli(config-cert)#
Call up the command with the following parameters:
show-info idx <integer(1-100)>}
The parameter has the following meaning:
Number corresponding to a specific certificate. Enter the required number.
The information on the certificate is displayed.
You display the indexes of the certificate with the show idx command.
To Next Page
Loading...
