Siemens SCALANCE S615 - Username; Password

Network protocols
6.5 DNS
SCALANCE S615 Command Line Interface
220 Configuration Manual, 06/2015, C79000-G8976-C406-02
6.5.5.4
username
Description
With this command, you configure the user name with which the device logs on to the
dynamic DNS server.
Requirement
You are in the DDNS Client configuration mode.
The command prompt is as follows:
cli(config-ddnsclient)#
Syntax
Call up the command with the following parameters:
username {show-services | <index> <username>}
The parameters have the following meaning:
Parameter
Description
Range of values / note
show-services
Lists the available providers.
-
index
Number corresponding to a specific
provider.
Specify a valid number.
username
User names
Specify the negotiated user name.
Result
The user name is configured.
Further notes
You display this setting and other information with the show ddnsclient information
command.
You configure the password with the
password command.
6.5.5.5
password
Description
With this command, you configure the password with which the device logs on to the
dynamic DNS server.