Functions specific to SCALANCE
3.1 PLUG
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
89
Commands in the Plug Configuration mode
This section describes commands that you can call up in the Plug Configuration mode.
In the Global Configuration mode, enter the
plug command to change to this mode.
● If you exit the Plug Configuration mode with the
exit command, you return to the Global
Configuration mode.
● If you exit the Plug Configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you delete the device configuration stored on the C-PLUG or KEY-
PLUG.
● There is a device configuration on the C-PLUG or KEY-PLUG.
● You are in the Plug Configuration mode.
The command prompt is:
cli(config-plug)#
Call the command without parameters:
factoryclean
The device configuration on the C-PLUG or KEY-PLUG is deleted.
To Next Page
Loading...
Need help?
General
