Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
345
Call up the command with the following parameters:
prerule telnet ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
The parameters have the following meaning:
Keyword for the interface
Type or speed of the interface Specify a valid interface.
Interface index Specify a valid interface
index.
Enables the predefined firewall rule on all inter-
-
Enables the predefined firewall rule.
Disables the predefined firewall rule.
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode (Page 313)".
The predefined firewall rule Ping is enabled on the relevant interface.
You display this setting and other information with the show firewall pre-rules ipv4
command.
You list the available interfaces with the
prerule ipv4 show-int command.
With this command, you configure user-defined protocols. You select a protocol name and
assign a protocol number to it.
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
To Next Page
Loading...
Need help?
General
