Configuration
2.2 Load and Save
SCALANCE S615 Command Line Interface
78 Configuration Manual, 06/2015, C79000-G8976-C406-02
With this command, you activate and configure the password for a file.
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Call up the command with the following parameters:
password {showfiles|filetype<filetype>[pw<password>]}
The parameters have the following meaning:
Shows the available files
Shows that the file type follows that will be loaded
Keyword for the password -
Password Enter the password for
The password for the file is configured and activated.
You disable the password with the no password command.
To Next Page
Loading...
Need help?
General
