Siemens SCALANCE S615 - Commands in the Global Configuration Mode; Ipsec

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
358 Configuration Manual, 06/2015, C79000-G8976-C406-02
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameter assignment:
show ipsec remoteend
Result
The configurations are displayed.
9.3.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
9.3.2.1
ipsec
Description
With this command, you change to the IPSEC configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ipsec