Siemens SCALANCE S615 - No Local-ID

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
383
Further notes
You display this setting and other information with the show ipsec conn-authentication
command.
You remove the local ID with the
no local-id command.
9.3.6.6
no local-id
Description
With this command, you remove the local ID.
Requirement
You are in the IPSEC AUTHENTICATION configuration mode.
The command prompt is as follows:
cli(config-conn-auth)#
Syntax
Call the command without parameter assignment:
no local-id
Result
The local ID is removed.
Further notes
You display this setting and other information with the show ipsec conn-authentication
command.
You configure the local ID with the
local-id command.