System time
4.3 SNTP client
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
137
sntp client addressing-mode
Description
With this command, you configure the addressing mode of the SNTP client as unicast or
broadcast.
● The SNTP client is activated.
● You are in the SNTP Configuration mode.
The command prompt is:
cli(config-sntp)#
Call up the command with the following parameters:
sntp client addressing-mode{unicast|broadcast}
The parameters have the following meaning:
configures the SNTP client in unicast
Default: unicast enabled
configures the SNTP client in broad-
cast mode
-
The addressing mode of the SNTP client is configured.
You display this setting and other information with the show sntp status command.
You display the settings for the unicast mode with the
show sntp unicast-mode status
command.
You display the settings for the broadcast mode with the
show sntp broadcast-mode status
command.