Siemens SCALANCE S615 - Dnsproxy

Network protocols
6.5 DNS
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
209
cli(config)#
Syntax
Call the command without parameter assignment:
dnsclient
Result
You are now in the DNS CLIENT configuration mode.
The command prompt is as follows:
cli(config-dnsclient)#
Further notes
You exit the DNS CLIENT configuration mode with the end or exit command.
6.5.2.3
dnsproxy
Description
With this command, you change to the DNS PROXY configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
dnsproxy
Result
You are now in the DNS PROXY configuration mode.
The command prompt is as follows:
cli(config-dnsproxy)#
Further notes
You exit the DNS PROXY configuration mode with the end or exit command.