Load control
7.2 Dynamic MAC aging
SCALANCE S615 Command Line Interface
280 Configuration Manual, 06/2015, C79000-G8976-C406-02
The section describes commands with which the aging of dynamically learned entries is
configured in a MAC address list.
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
show mac-address-table aging-time
Description
To ensure that the address entries are up-to-date, MAC addresses are only kept in the
address table for a specified time.
This command shows the time after which the MAC addresses are removed from the
address table.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show mac-address-table aging-time
The time is displayed.
To Next Page
Loading...
