Network protocols
6.6 SNMP
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
229
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you enable the SNMP agent function.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
snmpagent
The SNMP agent function is enabled.
You disable the SNMP agent function with theno snmpagent command.
To Next Page
Loading...
Need help?
General
