Siemens SCALANCE S615 - Show Ddnsclient Information; Commands in the Global Configuration Mode; Introductory Sentence for the Global Configuration Mode; Dnsclient

Network protocols
6.5 DNS
SCALANCE S615 Command Line Interface
208 Configuration Manual, 06/2015, C79000-G8976-C406-02
6.5.1.2
show ddnsclient information
Description
This command shows the configuration of the dynamic DNS client.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameters:
show ddnsclient overview
Result
The configuration is displayed.
6.5.2
Commands in the global configuration mode
6.5.2.1
Introductory sentence for the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
6.5.2.2
dnsclient
Description
With this command, you change to the DNS CLIENT configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows: