Siemens SCALANCE S615 - No Subnet-Vlan

Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
152 Configuration Manual, 06/2015, C79000-G8976-C406-02
Result
The classification is enabled.
Further notes
You disable the setting with the no subnet-vlan command.
You can display the status of this function and other information with the
show vlan device
info
command.
5.1.2.9
no subnet-vlan
Description
With this command, you disable the subnet-based VLAN classification on all interfaces.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no subnet-vlan
Result
The classification is disabled.
Further notes
You enable the setting with the subnet-vlan command.
You can display the status of this function and other information with the
show vlan device
info
command.