Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
359
You are now in the IPSEC configuration mode.
The command prompt is as follows:
cli(config-ipsec)#
You exit the IPSEC configuration mode with the end or exit command.
Commands in the IPSEC configuration mode
This section describes commands that you can call up in the IPSEC configuration mode.
In the Global configuration mode, enter the
ipsec command to change to this mode.
● If you exit the IPSEC configuration mode with the
exit command, you return to the Global
configuration mode.
● If you exit the IPSEC configuration mode with the
end command, you return to the
Privileged EXEC mode.
connection name
Description
With this command, you change to the IPSEC CONNECTION configuration mode. If a
suitable VPN connection does not exist, a VPN connection is first created.
You are in the IPSEC configuration mode.
The command prompt is as follows:
cli(config-ipsec)#
Call up the command with the following parameters:
connection name <name(122)>
The parameter has the following meaning:
Name of the VPN connection Enter the name for the VPN con-
nection.
Maximum of 122 characters
To Next Page
Loading...
Need help?
General
