Diagnostics
10.1 Event and fault handling
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
431
With this command, you configure the threshold values for the sending of system event
notifications.
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli (config-events) #
Call up the command with the following parameters:
severity { mail | log | syslog } { info | warning | critical }
The parameters have the following meaning:
Specifies the threshold value for send-
ing system event messages by e-mail.
-
Specifies the threshold value for enter-
ing system event messages in the log
table.
-
Specifies the threshold value for enter-
ing system event messages in the
-
System events are processed as of the
severity level "Information".
-
System events are processed as of the
severity level "Warning".
-
System events are processed as of the
severity level "Critical".
-
The settings for sending system event messages are configured.
The "severity" function is enabled.
You disable the setting with the no severity command.
You display the status of this function and other information
show events severity
To Next Page
Loading...
Need help?
General
