Siemens SCALANCE S615 - EC declaration of conformity; ATEX

Configuration
2.2 Load and Save
SCALANCE S615 Command Line Interface
72 Configuration Manual, 06/2015, C79000-G8976-C406-02
The parameters have the following meaning:
Parameter
Description
Range of values / note
filetype
Keyword for a file type to be loaded
-
filetype
Name of the file type max. 100 characters
tftp
Keyword for a TFTP server
-
ipv4
Keyword for an IPv4 address
-
ipv4-address
Value for an IPv4 unicast address Enter a valid IPv4 unicast ad-
dress.
port
Keyword for the port of the server via
which the TFTP connection runs
-
tcp port
Number of the port 1 … 65535
Default: 69
file
Keyword for a file name to be assigned
-
filename
Name of the file
max. 100 characters
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The file is saved on the TFTP server.
Further notes
With the "show loadsave files" command, you can display the file types.
2.2.4
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
2.2.4.1
loadsave
Description
With this command, you change to the LOADSAVE configuration mode.