Siemens SCALANCE S615 - Service Name Set Prot

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
350 Configuration Manual, 06/2015, C79000-G8976-C406-02
Result
The corresponding service is deleted.
Further notes
You display the available service names with the service show-names command.
You create a service with the
service name command.
You display this setting and other information with the
show firewall ip-services
command.
9.2.4.39
service name set prot
Description
With this command, you change the protocol.
Requirement
● The service name has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
service name <string(32)> set proto {udp|tcp}
The parameters have the following meaning:
Parameter
Description
Range of values / note
string
Service name Specify a valid service name.
Maximum of 32 characters
UDP
The service is valid only for UDP
frames.
-
TCP
The service is valid only for TCP
frames.
-
Result
The protocol of the relevant service has been changed.