Siemens SCALANCE S615 - Napt Type Ipv4

Layer 3 functions
8.1 NAT
SCALANCE S615 Command Line Interface
290 Configuration Manual, 06/2015, C79000-G8976-C406-02
Requirement
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Syntax
Call up the command with the following parameters:
no masquerading {<interface-type> <num(0-4094)>|all-int|show-int}
The parameters have the following meaning:
Parameter
Description
Range of values / note
interface-type
Type or speed of the interface
Specify a valid interface.
num
Number corresponding to a specific interface. Enter the required number.
0 ... 10
all-int
Disables the rules for IP masquerading on all
interfaces.
-
show-int
Lists the available interfaces.
-
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL NAT configuration mode (Page 288)".
Result
The rules for IP masquerading are disabled on the relevant interface.
Further notes
You enable IP masquerading with the masquerading-nat command.
8.1.3.3
napt type ipv4
Description
With this command, you create a NAPT rule.
Requirement
● VLAN interface with subnet assignment
● You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#