Network protocols
6.4 DHCP server
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
201
Call up the command with the following parameters:
no option <option-code>
The parameter has the following meaning:
The specified DHCP option is deleted.
You configure the DHCP option 67 with the option value-string command.
You configure the DHCP options 3, 6 and 66 with the
option command.
You configure all other DHCP options with the
option value-hex command.
option value-hex
Description
With this command, you create DHCP options that contain a hexadecimal value as DHCP
parameter. The various DHCP options are defined in RFC 2132.
The exceptions are the DHCP options: 1, 3, 66 and 67. You configure the DHCP options 3, 6
and 66 with the command
option (IP address) and the DHCP option 67 with the command
option value-string.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Call up the command with the following parameters:
option <option-code> value-hex <dhcp-param>
To Next Page
Loading...
Need help?
General
