Description
1.4 Symbols of the CLI commands
SCALANCE S615 Command Line Interface
24 Configuration Manual, 06/2015, C79000-G8976-C406-02
Symbols of the CLI commands
Symbols for representing CLI commands
When setting parameters for CLI commands, the following characters are used:
Instead of the expression in parenthesis, enter a value.
[ ... ] optional parameter Instead of the expression in parenthesis, you can enter a
Instead of the expression in parenthesis, enter a value.
( ... - ... ) Range of values Enter a value from this range.
Select one more elements from the list.
Select exactly one element from this list.
These characters are used in combinations to describe mandatory and optional entries.
There is a general description of some of these combinations below:
< Parameter > Instead of the expression in parentheses<>, enter a permitted
< < Unit (a - b) > Instead of the expression in parentheses <>, enter a value from
the range "a" to "b".
The unit to be used is specified before the brackets () and is
also replaced by the entry.
[<Parameter 1 >< Parameter 2 >] The parameter pair is optional.
If you use the parameter assignment, you need to enter a per-
mitted value to replace both expressions in parenthesis <>.
[ [ Keyword < Unit (a - b)>] The parameter assignment is optional.
If you use the keyword, you need to enter a value from the
range "a" to "b" to replace the expression in parenthesis <>.
[keyword { A | B | C }] The parameter assignment is optional.
If you use the keyword, you need to specify exactly one of the
Keyword [A] [B] [C] After the keyword, enter no or several of the values "A", "B" or