Siemens SCALANCE S615 - Ip Dhcp-Server; No Ip Dhcp-Server

Network protocols
6.4 DHCP server
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
193
6.4.2.1
ip dhcp-server
Description
With this command, you enable the DHCP server on the device.
Note
To avoid conflicts with IP
v4 addresses, only one device may be configured as a DHCP
server in the network.
Note
Maximum number of IP addresses
The maximum number of IPv4 addresses that the DHCP server supports is 100. In other
words, a total of 100 IPv4 addresses (dynamic + sta
tic).
With the static assignments, you can create a maximum of 20 entries.
Requirement
● NAT is enabled in Client mode
● You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ip dhcp-server
Result
The DHCP server is enabled.
Further notes
You disable the DHCP server with the no ip dhcp-server. command.
6.4.2.2
no ip dhcp-server
Description
With this command, you disable the DHCP server on the device.