Diagnostics
10.1 Event and fault handling
SCALANCE S615 Command Line Interface
426 Configuration Manual, 06/2015, C79000-G8976-C406-02
Disables the client that sends the e-mails
Disables all clients at once
The client selected for the transfer is disabled.
You display the status of the events and the clients with the show events config command.
You enable the function with the
client config command.
With this command, you configure which of the various message types of the device will be
stored or forwarded.
The following events or message types are available:
● Message if there is cold or warm restart
● Message when there is a status change on a physical interface
● Message if there is an incorrect login
● Message when there is a status change in the power supply
● Message when there is a status change in the error monitoring
● Message when using VPN
● Message when using firewall rules
● Message when changing the connection status
● Message on connection establishment and when the configuration changes
● Message when there is a status change of the digital input.
These messages can be processed by the clients in different ways:
● Entry in the logbook of the device
● Sending the message to the Syslog server of the system
● Sending an e-mail
● Sending an SNMP trap
● Lighting up of the error LED
● Switching at the digital output
To Next Page
Loading...
