Configuration
2.1 System
SCALANCE S615 Command Line Interface
46 Configuration Manual, 06/2015, C79000-G8976-C406-02
The parameters have the following meaning:
Type or speed of the interface
Specify a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If no parameters are specified, the counters for all interfaces are reset.
The counters of the interface are reset.
You can display the statistical information of the interfaces with the show interfaces -
counters
command.
configure terminal
Description
With this command, you change to the Global configuration mode.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call the command without parameters:
configure terminal
You are now in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General
