Siemens SCALANCE S615 - Show Ip Telnet; Commands in the Global Configuration Mode

Network protocols
6.1 IPv4 protocol
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
175
6.1.1.7
show ip telnet
Description
This command shows the admin status and the port number of the Telnet server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip telnet
Result
The admin status and the port number of the Telnet server are displayed.
6.1.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.